By 
Basement waterproofing is the best way to get rid of wetness in your basement. It is common knowledge that a wet basement can cause health hazards by allowing mould and mildew to grow. It can also promote an infestation of insects and water damage, which can compromise the integrity of the home’s foundation.
If you are searching for basement waterproofing overland park ks tips, the guide provided in this write-up will help you. Here is how to waterproof your basement in 5 steps:
Step 1: Clean The Basement
Cleaning the basement is the first step in basement waterproofing. Dirt and impurities will undermine the efficiency of any waterproofing materials or products applied on the basement surface. To get maximum results, clean the basement thoroughly. Moreover, you must remove all the existing coatings on the surface of the basement because most waterproofing products only work effectively when applied directly to the substrate.
Remove old paint with a sandblaster or a wire brush. Ensure that the surface is properly cleaned. Wash the walls clean using dish soap, warm water, and a scrub brush. Add a cup of bleach to the solution to clean the mould in the basement. Meanwhile, check the composition of the dish soap and ensure that it does not contain ammonia before adding bleach to it. Rinse the walls and floor thoroughly with clean water.
Step 2: Plug Holes
Do not overlook any holes and gaps. Ensure to plug all holes and gaps with hydraulic cement. All holes in masonry and large cracks can be filled and sealed using hydraulic cement, which will also prevent water from seeping into the basement regardless of the pressure.
Step 3: Fill Cracks
After plugging holes and gaps in the basement, the next step is to look out for fine lines and cracks. No matter how small, cracks can grow bigger if left without being filled. Fill all small cracks with masonry crack filler. This will ensure that water cannot leak into the basement and compromise the entire basement waterproofing project later in future.
Step 4: Seal Openings
The next step in basement waterproofing is the caulking and sealing of all visible openings around doors, windows, and window wells. Use an elastic sealant, such as Lexel Sealant or Big Stretch Sealant, which are flexible and waterproof.
Step 5: Add Waterproof Coating
The final step of basement waterproofing is the application of a waterproof coating to the surface of the basement that has been cleaned and all holes and cracks filled and sealed. You can use DRYLOK Clear Masonry Waterproofer to finish up the waterproofing project. The product offers protection against hydrostatic pressure and water seepage. Work the waterproof coating into the pores of the masonry.
Takeaway
If you want to waterproof your basement, above are the 5 steps you must take to get the best results possible. Keep in mind that your basement is crucial to the overall health and aesthetics of the building.
Comments