At some point, most homeowners wonder whether their water needs help. Maybe it tastes odd, leaves spots or has been mentioned in a news story. The market answers with hundreds of products, from a pitcher filter to a system bolted to the main line. Before comparing brands, it helps to settle one basic question: do you want to treat a single tap or all the water entering the house?
A local plumber can help you weigh that choice. OMNI Plumbing is a family-owned company in Delano, Minnesota, founded by certified plumber Roy Haase, and its website lists water filtration among four services. The site gives no details about what that service includes, so this article sticks to general guidance from the state.
Start With Whether You Need Treatment at All
The Minnesota Department of Health’s home water treatment facts page begins with a surprise. It says most Minnesotans do not need home water treatment. The Department’s advice is to first remove the source of contamination or switch to a safer supply. Treatment is for cases where that is not possible.
The page also points out that public water systems are tested for over 100 contaminants and publish an annual Consumer Confidence Report, while private well owners are responsible for testing their own water. It also warns about water treatment scams, which is a good reason to learn the basics before a salesperson arrives.
The Two Basic Choices Side by Side
The Department describes two kinds of units, which differ mainly in how much water they treat. The table below sets them next to each other, using the Department’s own descriptions.
| Question | Point of use | Point of entry |
|---|---|---|
| What it treats | One tap | All water entering the home |
| Common use | Often drinking and cooking | Whole house |
| Installation | You can install it yourself or hire a professional | You can install it yourself or hire a professional |
| Cost | Prices across all units range from under $20 to thousands of dollars | Prices across all units range from under $20 to thousands of dollars |
| Upkeep | Maintain it as the maker directs | Maintain it as the maker directs |
The cost and installation cells are the same for both columns because the Department gives one range for all units. Your own quote will vary by product and by plumber.
Match the Unit to the Problem
A key warning on the state page is that no single treatment unit can remove all contaminants in water. If you have more than one concern, you may need more than one unit. That is why defining your goal comes before shopping. The Department lists common reasons as taste, smell, appearance or a specific contaminant such as lead, arsenic or nitrate.
Look for a Certification Label
The Department advises choosing a unit certified by NSF, Underwriters Laboratories or the Water Quality Association for the contaminant you want to address, when certification exists. It notes that not every contaminant has a certification, and that a water treatment professional may be needed in those cases.
Hiring Help the Right Way
If you decide to bring in a pro, the page recommends confirming that the contractor is a licensed plumber or a licensed water conditioning contractor, using the Minnesota Department of Labor and Industry’s license lookup. Check before work starts, and ask any contractor to put the scope in writing.
After the Install
Test your treated water after installation to confirm the unit is working, then follow the manufacturer’s maintenance instructions. The Department is blunt about this: units that are not properly maintained lose their effectiveness over time, and in some cases can make water quality worse and cause illness. Filters need changing, and a system that nobody looks after is worse than none.
A Last Word
Choosing between one tap and the whole house is mostly a question about your goal and your water source. Learn what is in your water, decide what you want to fix, and then pick the smallest unit that does the job. A licensed plumber can help with the installation, but the thinking starts with you.












Comments